✨ Restore, Revive, Repeat! ✨
Scratch Doctor Enamel Touch Up Paint is a 15ml quick-drying solution designed to effortlessly repair scratches and chips on various surfaces, including kitchen appliances and bathroom fixtures. With a convenient brush for easy application and a waterproof finish, this product is perfect for both DIY enthusiasts and professionals alike.
Manufacturer | The Scratch Doctor |
Part Number | ENAMEL_PAINT |
Product Dimensions | 0.1 x 2.3 x 6.7 cm; 20 g |
Manufacturer reference | ENAMEL_PAINT |
Size | 15 ml (Pack of 1) |
Colour | Black |
Finish | Gloss |
Material | metal |
Coverage | Small touch up areas |
Special Features | Fast-Drying |
Usage | Interior/Exterior |
Included Components | Brushes |
Batteries included? | No |
Batteries Required? | No |
Item Weight | 20 g |
D**D
Easy to use and looks good.
Easy to use and provides a good finish after a couple of coats. Used it on both radiators where the paint had flaked off, and on a repaired enamel loo system top which had been broken and repaired. Now both looking much better. Would recommend.
A**D
It works better than radiator paint
I had previously tried touching up some marks using radiator paint and it was a didsaster. After reading the reviews I tried this and its much better. You might need 2 coats but its far better coverage and stickability. I don't know about heat resistance since i didn't do anything hot, but on a sink, microwave and cooker side panel it has worked well.The only snag is the bottle is breakable and I left it sitting on a washer/dryer which, when it started vibrating, caused it to drop on the floor and smash, leaving white paint everywhere! Difficult to clean off: white spirit is only partially effective. Cellulose thinners are better but a bit iffy to use.
G**A
Excellent product thank you
Good touch up
G**H
A bit thick and 'gummy' therefore hard to get a smooth surface
I've used this to repair some rusting bath enamel (after using some hammerite kurust), but its really 'gummy' for want of a better description and goes on too thick. As such, its really hard to get a smooth surface. The brush creates streaks if you go over it after the first initial brush stroke and when trying to even out the surface, creating marks. I had to do several coats, sanding down the lumps to get a smooth surface.I will try it again with a bit of white spirit to dilute it and hopefully it might be a bit smoother. The one benefit of this though, is that as I'm repairing enamel on the side of the bath, being so thick means it doesn't easily drip vertically down, which is a useful property in this instance! Still I would prefer a smooth surface and to use a paper towel to catch drips instead.In terms of durability it does bubble up, as it seems the enamel under the bath is still suffering from rust despite it being cured on the exposed parts, though this is more of an issue with the rust itself than this product.
P**S
Easy to use nice touch up paint for white goods
I used this on a Bosch washing machine after the delivery guys scratched it I only saw it after they left ! Well I purchased this based on very good reviews and it doesn’t disappoint, just take your time don’t expect to paint deep scratches with one thick coat as you will make a mess with paint runs my advice is use a low tack masking tape adjacent to the touch up area will be applied especially below as this can run if you use the brush that’s attached to the cap just don’t load the little brush up with too much product wipe it off on a piece of kitchen roll if your brush gets loaded up , it’s expensive but it goes a long way I doubt you would use the lot unless you have large areas to touch up , I can highly recommend this I found the colour a very good match .
T**M
Thick.
Pricy item. Very thick, does not self level and impossible to apply thin cost with the brush in the cap. Can't comment on durability. Takes a long time to dry completely probably 3 days in my case (cooker top). I will update review of I can in a few months.
D**F
saved our microwave
Bought this to try and keep our trusty microwave running.....the inside had developed a few nasty rust patches so, after rubbing down the areas with fine sandpaper I applied a coat to the affected area and watched as the brush marks magically disappeared.A few hours later I applied a second coat, this time covering the whole area of the "well" in the bottom of the cavity to make it look a bit more aesthetically pleasing, again the brush marks all disappeared to leave a super smooth finish.Left it to dry fully overnight and replaced the small wheeled carrier support and glass dish and, 3 weeks on it shows no signs of wearing or marking.One word of caution...it does give off one hell of a stink whilst drying !
M**H
Easy to use
Very effective touch up paint, dries quickly and is easy to use
Trustpilot
2 weeks ago
2 months ago